A development in this regard is, however, contemplated.Дie Zeitwaage Chronoskop CHR-9 ist ein elektronisches Mess- und PrГјfgerГ¤t fГјr die Produktion, Reparatur und Service von mechanischen Uhren. In these cases, a longer measurement is needed which provides a stable average value is necessary.Д¬AN VALUES AS PRESSURE, ENVIRONMENTAL TEMPERATURE AND HUMIDITY IN THE MEASUREMENT BE INVOLVED? This behavior can be observed on the graphical representation of measuring well. If the measurement result is near an ideal clock, it can even mean different signs of the measurement result. Note, however, that the transition of a clock, for example, in the first minute is different from the next. WHY DO I SOMETIMES DIFFERENT RESULTS IN TWO SUCCESSIVE FOLLOWING MEASUREMENTS?ДЄs a result of the measurement is, when switched integration time, the current measured value, or with activated time integration, the measured value, which is averaged over the total duration of the measurement. With deactivated integration to measure only the last 5 seconds are considered. In a Schagzahl of 18000, the maximum integration time is thus 65000/1800 = 36,1h. The maximum measurement time (and hence also the integration time) shall be determined from the stroke rate. Our Geraet recorded maximum 65,000 strokes in the measurement. HOW LONG CAN THE MAXIMUM LENGTH MEASUREMENT / INTEGRATION TIME BE? Due to large range of third-party, we can not offer an adapter for connection.

When using the appropriate adapter to 3.5mm jack, it is possible to use piezoelectric microphones from other manufacturers, as they are not operated or reinforced with its own power supply. Would still perform a new calibration, however, please order the optional DCF77 receiver.Д¬AN MICROPHONES THIRD PARTY BE CONNECTED? Recalibration is not necessary for measurements. Compact design (9cm x 9cm x 4cm) gives the device manageability it is easy to transport and can be due to the external battery pack used as mobile device.Д®ach appliance that leaves our house is calibrated prior to shipping. The use of the latest microcontroller technology in conjunction with modern SMD technology allows a compact solution that does not need to be ashamed in front of expensive large-scale equipment. Thanks to a balance on the radio signal DCF77 with the atomic clock in Mainflingen an accuracy of up to a few seconds per year is achieved, which would otherwise only be realized with great technological effort. With the headphone jack, you can listen to the operation of a clock directly. All taken from the measurement information is displayed on the illuminated graphic display. For evaluation, the observation of the signals on the time axis or a diagrammatic representation of the passage may be used. It can be determined values such as aisle, beat number, beat error and cycle time. CHR-9 is a fully electronic test instrument for measurement of mechanical watches that uses acoustic or optical signal of the clock. Chronoscope CHR-9 is our new timegrapher model.

Pc timegrapher software